Diary of a Network Geek

The trials and tribulations of a Certified Novell Engineer who's been stranded in Houston, Texas.

8/6/2001

Home Networking

Filed under: The Network Geek at Home — Posted by the Network Geek during the Hour of the Hare which is in the early morning or 7:00 am for you boring, normal people.
The moon is Waning Gibbous

Well, Day 1 of cable running didn’t go quite as well as I’d hoped. For one thing, I found out just how wimpy my cordless drills are. But, let me start from the begining….
Saturday, after going in for some tests and passing my kidney stone, I stopped at Lowe’s for some tools and supplies. Mainly, I got drill bits and wireties and that kind of junk. But, I also got a *good* stud finder and gloves and breathing masks. Very important as I was going to be crawling around in a very dusty attic. But, by the time we got through with the rest of our day, I wasn’t up for running cable. So, Sunday afternoon, I got set up.
First, I changed into the crappiest clothes I could find. Jeans and an old, long-sleeved t-shirt. Then I got my hat on, scrunched my mask down, and pulled my gloves on. Then, I crawled up into the attic with my fiberglass pull-rods and started fishing around for an opening. No luck. So, I crawled out of the attic behind the “server room” (ie. closet) and headed up to the main attic with the other half of my pullrod. I fished it down and when I got back into the attic behind the server room, I was in luck. I pulled the rod back up some and tied the nylon cord that I planned to pull cable with to the end. Then, after thinking about it for a minute, I tied a second line to that one to setup my second long cable run. After that it was back up into the main attic to fish the pullrod up and over. I managed that and, as I bellycrawled back out, I pulled the second line with me. That should, I hope, miminize the number of trips to the dusties part of the attic. That was the last easy thing that happend,though.
At that point, I got into the attic over where our office will be and tried to fish the pullrod down. After a little manuvering, it seemed to go just fine. However, when I got down stairs and cut my first hole for the wall plate, there was no pullrod. So, I went back up into the attic and tried again. Still no luck. Well, this time I decide to cut a hole for the second wall plate that I planned on putting in, but still no luck. So, it was back up into the attic to see what was what. It was then that I discovered that I had fished the pullrod down the *outside* wall behind the brick facade. Damn. At that point I figured out that I needed to drill through the top plate of the wall so I could fish my line. That’s when I discovered that my cordless drills were just way wimpy. *sigh* And, in fact, that’s where I finally gave up for the day. I’ll go back to it tonight and see if I can finish drilling that hole. If I can, then the rest should be downhill. And, I console myself with the thought that this is the hardes of the cable runs. The work of a network geek is never done!


Powered by WordPress
Any links to sites selling any reviewed item, including but not limited to Amazon, may be affiliate links which will pay me some tiny bit of money if used to purchase the item, but this site does no paid reviews and all opinions are my own.